Your location:Home  Faq  Sugar Mill Chain & Sprockets

    Yes. For the wettest and most acidic positions - juice strainers, cush-cush elevators, wash tables - pins, bushes and rollers come as a matched stainless set in one grade: 2Cr13 hardened for standard juice, 17-4PH for high-humidity duty.

    Life depends on the station and the juice, not one figure. Judge it by elongation: a correctly specified, heat-treated chain stays within the take-up range far longer. Tell us the station and duty and we will set the specification.

    Yes. Our chains and sprockets interchange with the major international sugar-chain brands. Send the OEM part number or a drawing and we will confirm the match; a short length of the original chain lets us measure and match it exactly.

    Yes - OEM and replacement manufacturing are our core business. Send the old chain, a drawing or the pitch, inside width, pin diameter and attachment pattern, and we reproduce it dimension-for-dimension, with matching sprockets.

    Standard lead time is 60 days from receipt of the order and confirmation of the drawing; minimum order is 100 meter of chain. Crush-season timing matters - tell us your start date and for urgent breakdowns we can discuss an expedited slot.

    Split (two-piece) sprockets suit smaller drivers you can stop briefly: the halves bolt around the shaft, so replacement needs no dismantling. Segmental rims bolt onto a reusable hub and suit large drivers - the mill re-rims in place in one shift.

    The tooth profile must match the chain's actual pitch, not its nominal pitch. A stretched chain or a sprocket cut to a different pitch standard hammers the teeth and destroys both parts. SHINING cuts each sprocket to the measured pitch.

    Start with the pitch your sprockets already have: the 1131 to 2184 family all runs on 152.4 mm, so a strength upgrade usually means a new chain. Match the load - 209 kN (1131), 270-430 kN (09060/09061/09063), 450 kN (1796/2184).

    Yes, and we recommend it. Chain and sprocket should be engineered as one system. We supply solid, split and segmental sprockets, tooth-cut to the actual pitch of the chain.

If you have drawings, please email to sales@shiningco.com.